Share via


Wlan L1 Test 09 - Attempt a connection to a non-existent network

This automated test creates a wireless profile for a network that does not exist and tries to connect to the non-existent network.

Test details

Associated requirements

Device.Network.WLAN.Base.MeetScanAndConnReq Device.Network.WLAN.CSBBase.MeetScanAndConnReq

See the device hardware requirements.

Platforms

Windows 7 (x64) Windows 7 (x86) Windows RT (ARM-based) Windows 8 (x64) Windows 8 (x86) Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86

Expected run time

~2 minutes

Categories

Basic Certification

Type

Automated

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Wireless LAN (802.11) Testing Prerequisites.

This test will do the following:

  • Create a wireless profile for a network that does not exist.

  • Instruct the wireless service to connect to the created profile The device/driver is expected to quickly fail since the network is not visible.

  • If the connection start event is not seen within ten seconds, the test will fail.

  • If the associating message is not seen within eight seconds of connection start, the test will fail.

  • If the connection failure message is not seen within eight seconds of associating, the test will fail.

Troubleshooting

For troubleshooting information, see Troubleshooting Wireless LAN (802.11) Tests.

 

 

Send comments about this topic to Microsoft