Réduire la table des matières
Développer la table des matières
Développer Réduire
Ce contenu n’est pas disponible dans votre langue. Voici la version anglaise.

Sensor DataEvents Test (ARM)

If a client sets the change sensitivity to 0, data events will fire at the rate of the current report interval to within 20%, both for short (< 1 sec) and long (> 1 minute) values of the current report interval.

Data events should not be fired if the current report interval and change sensitivity (when applicable) are not met.

Sensors should not delay data reports more than 100% of the current report interval.

Data events should not be fired at a rate less than the minimum report interval.

Test details

Associated requirements

Device.Input.Sensor.ALS.SupportRequiredData Device.Input.Sensor.Base.DataEvents Device.Input.Sensor.Base.SupportDataTypesAndProperties

See the device hardware requirements.


Windows RT 8.1

Expected run time

~2 minutes


Basic Certification




Running the test

Before you run the test, complete the test setup as described in the test requirements: Sensor Device Testing Prerequisites.

If this test is being run against a GPS sensor device node, make sure that you are running the test in an environment in which you can receive a GPS signal.


For troubleshooting information, see Troubleshooting Device.Input Testing.

Ensure that the location permissions are enabled.

Ensure that the GPS sensor has a signal.



Send comments about this topic to Microsoft

© 2015 Microsoft