Run RSC Tests

This test validates receive-segment coalescing (RSC).

Test details

Running the test

Before you run the test, complete the test setup as described in the test requirements: LAN Testing Prerequisites.

Important  

The Windows HCK User's Guide - LAN Testing Prerequisites page recommends the HCK configuration of back-to-back test connection and a separate backchannel connection to the same network together with the HCK controller. It is important that in this configuration, the DUT (device-under-test) and the support network interface, be configured for DHCP so that when they are connected back-to-back, they are auto-configured with a '169.x.x.x' IP address. If this configuration is not available, then the RSC test might not be able to determine the correct client and corresponding support IP interfaces for the DUT (device-under-test). An alternate configuration is to configure the HCK Controller to be directly reachable from the DUT network – this typically requires that the test, support and controller machines be connected to the same switch. In this configuration, all network devices, except for the controller NIC, the test NIC and the support NIC, should be disabled. Other configurations are less likely to succeed."

Troubleshooting

For troubleshooting information, see Troubleshooting LAN Testing.

More information

Command syntax

Note  

For command-line help for this test binary, type /h.

File list

Send comments about this topic to Microsoft