IOCTL_INTERNAL_USB_GET_PORT_STATUS control code

The IOCTL_INTERNAL_USB_GET_PORT_STATUS I/O request queries the status of the PDO.

IOCTL_INTERNAL_USB_GET_PORT_STATUS is a kernel-mode I/O control request. This request targets the USB hub PDO. This IOCTL must be sent at IRQL = PASSIVE_LEVEL.

Input Parameters

Parameters.Others.Argument1 should be a pointer to a ULONG to be filled in with the port status flags.

Output Parameters

Parameters.Others.Argument1 points to a ULONG that has the port status flags filled in. The flags can be one or both of USBD_PORT_ENABLED (bit 0) or USBD_PORT_CONNECTED (bit 1). When the USB_PORT_ENABLED bit is set, the port has been enabled after resetting the device connected to the port. When the USB_PORT_ENABLED bit is clear, software has disabled the port or hardware has disabled it due to abnormal hardware conditions. When the USB_PORT_CONNECTED bit is set, the host controller root hub or external hub has detected that a device is connected to the port. When the USB_PORT_CONNECTED bit is clear, the host controller root hub or external hub has detected that a device is not connected to the port.

I/O Status Block

The bus or port driver sets Irp->IoStatus.Status to STATUS_SUCCESS or the appropriate error status.

Requirements

Header

Usbioctl.h (include Usbioctl.h)

 

 

Send comments about this topic to Microsoft

Show: