IOCTL_BIOMETRIC_RESET control code

The IOCTL_BIOMETRIC_RESET IOCTL resets the device to a known or idle state, according to the current power state. Vendor-supplied WBDI drivers must support this IOCTL.

Input Parameters

None

Output Parameters

The AssociatedIrp.SystemBuffer member points to a buffer that contains a WINBIO_BLANK_PAYLOAD structure.

The vendor-supplied driver can optionally return a DWORD-sized buffer that specifies the buffer size necessary for the requested operation.

I/O Status Block

Indicates whether the DeviceIoControl call to the driver completed and the OUT payload is valid.

The Status member is set to one of the values in the following table.

Status valueDescription

S_OK, STATUS_SUCCESS

The operation completed successfully. If the size of data returned is DWORD, the payload contains the size of the buffer necessary for the call. Otherwise, the payload contains the full output buffer.

E_INVALIDARG

The parameters were not specified correctly.

E_UNKNOWN

Any other failure that prevents the payload from being filled in.

E_UNEXPECTED

Any other failure that prevents the payload from being filled in.

E_FAIL

Any other failure that prevents the payload from being filled in.

 

Remarks

IOCTL_BIOMETRIC_RESET cancels a data collection IOCTL, if one is pending. If there is a vendor-specific operation in progress, the driver should cancel the operation and reset the device whenever possible.

If the vendor-supplied driver passes back the entire payload, it should fill in the WinBioHresult member of WINBIO_BLANK_PAYLOAD with the status of the Biometric operation.

Requirements

Version

Available in Windows 7 and later versions of Windows.

Header

Winbio_ioctl.h

 

 

Send comments about this topic to Microsoft

Show: