Test.ConvergeDivergeDiagonal
TOC
Collapse the table of content
Expand the table of content

Test.ConvergeDivergeDiagonal

This test verifies that two contacts are reported properly when converged and diverged within 14 millimeters of each other.

Test details

Associated requirements

Device.Input.PrecisionTouchpad.Precision.ContactDivergence

See the device hardware requirements.

Platforms

Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86

Expected run time

~2 minutes

Categories

Certification

Type

Manual

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

This test requires contacts that move very precisely in very specific distances. It is recommended that a precision rig or robotic solution is used to perform these tests.

  1. Place two 7 millimeter precision contacts on touchpad device next to each other vertically separated by distance as instructed on the screen.

  2. As instructed, move contacts diagonally (at a 45 degree angle) either towards each other or apart. Five iterations per direction for both converge and diverge. If the two contacts remain distinct and no errors are detected, the test will automatically pass each iteration and advance to the next.

Troubleshooting

For troubleshooting information, see Troubleshooting Device.Input Testing.

If you get an error of “[17] not enough separate of points” or “[18] too much separation of points: ####”, ensure that the widest distance between two contacts is always > 30mm and the smallest distance is always < 11mm.

More information

Command syntax

CommandDescription

ptlogo.exe Test.ConvergeDivergeDiagonal.json

Runs the test.

 

File list

FileLocation

ptlogo.exe

<testbinroot>\input\PrecisionTouchpad\

config.json

<testbinroot>\input\PrecisionTouchpad\

Test.ConvergeDivergeDiagonal.json

<testbinroot>\input\PrecisionTouchpad\

 

 

 

Send comments about this topic to Microsoft

Show:
© 2016 Microsoft