Hardware Dev Center

Test.DeviceWidth

This manual test verifies that a Windows Precision Touchpad width is reported correctly by the device.

Test details

Associated requirements

Device.Input.PrecisionTouchpad.Hardware.Width

See the device hardware requirements.

Platforms

Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86

Expected run time

~2 minutes

Categories

Certification

Type

Manual

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

The test asks you to validate that the physical width of the touchpad is the same as that reported by the device. You should measure the width of the touchpad by using a ruler, and compare that value to the value that is displayed by the test. If the values match*, you should manually pass the test. If they do not match, you should fail the test.

Note  

Because the digitizer might be slightly smaller than the physical device, the measured width can be as much as 4mm greater than that which is reported by the device and still pass the test.

Troubleshooting

For troubleshooting information, see Troubleshooting Device.Input Testing.

More information

To run the test outside of Windows Hardware Certification Kit (Windows HCK) Studio, type the following command in a command prompt window that has administrative privileges:

PTLogo.exe Test.DeviceWidth.json

 

 

Community Additions

ADD
Show:
© 2015 Microsoft