Test.FFU

The test verifies that the device can correctly perform a field firmware upgrade.

Test details

Associated requirements

Device.Input.PrecisionTouchpad.FieldFirmwareUpdateable System.Client.PrecisionTouchpad.PrecisionTouchpad

See the system hardware requirements.

Platforms

Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86

Expected run time

~2 minutes

Categories

Certification

Type

Manual

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

Note  

PTLogo Test.FFU.json is used to manually test whether this requirement is met, as per the following validation steps. After all steps have been completed, run PTLogo Test.FFU.json to determine validation status.

 
  1. Verify the current firmware version by running the following command from an elevated command or PowerShell prompt: GetThqaBlob.

  2. Record the firmware version (RevisionID).

  3. Perform the steps that are indicated by the device manufacturer to upgrade the firmware either by using a UEFI capsule update or stand-alone user mode executable with firmware payload.

  4. Verify the new firmware version by running the following command from an elevated command or PowerShell prompt: GetThqaBlob.

  5. Verify that the firmware version (RevisionID) is different from the previously recorded one.

  6. Run the Test.DeviceType test.

  7. If step 5 was successful, manually pass the test (press P). Otherwise, press F to fail the test.

Troubleshooting

For troubleshooting information, see Troubleshooting Device.Input Testing.

More information

Command syntax

CommandDescription

ptlogo.exe Test.FFU.json

Runs the test.

 

File list

FileLocation

ptlogo.exe

<testbinroot>\input\PrecisionTouchpad\

config.json

<testbinroot>\input\PrecisionTouchpad\

Test.FFU.jsonTest.DeviceBezel.json

<testbinroot>\input\PrecisionTouchpad\

GetTHQABlob.exe

<testbinroot>\Digitizer\Win8Touch\

 

 

 

Send comments about this topic to Microsoft

Show: