NetworkDirect Disconnect Scheme

The scheme described here applies to both NDSPI version 2 and NDKPI. The following terms are used:

  • ND is used to refer to NDSPI or NDK.
  • NdDisconnect is used to refer to the function call that an ND consumer makes in order to initiate a graceful disconnect. For NDSPI, this is INDConnector::Disconnect. For NDKPI, it is NdkDisconnect (NDK_FN_DISCONNECT).
  • NdDisconnectIndication is used to refer to the indication delivered by an ND provider to an ND consumer when the ND provider receives a graceful disconnect from the peer or detects that the connection was aborted due to any reason (other than the local NDK consumer's own initiation such as issuing NdDisconnect or NdCloseConnector).
Below, A and B refer to the two sides of an ND connection. Consumer A refers to the ND consumer on side A, provider A refers to the ND provider on side A, and similarly Consumer B/Provider B refers to those same entities on side B.

When consumer A calls NdDisconnect, provider A must send a graceful disconnect notification to side B and complete consumer A's NdDisconnect request only when both of the following conditions occur:

  • Either:
    • A graceful disconnect notification is received from B (which leads to successful completion of consumer A's NdDisconnect), or
    • An error such as connection abortion or time-out occurred (which leads to consumer A's NdDisconnect to be completed with a failure).
  • All DMA activity on the QP is finished (including DMA activity for work requests that were posted with silent-success flag).

When provider B receives a graceful disconnect notification from A or detects that the connection is aborted, provider B must deliver NdDisconnectIndication to consumer B if consumer B has not called NdDisconnect to provider B already. Since an incoming graceful disconnect notification or an abort event can race with the local consumer initiating NdDisconnect, local consumer must be prepared to handle an NdDisconnectIndication arriving after local consumer calls NdDisconnect. Note that an NdDisconnectIndication does not provide any guarantees in terms of work request completions.

A disconnected QP or connector cannot be reused by the consumer.

NetworkDirect does not have any notion of half-closed connections. Once NdDisconnect is completed (with success or failure), the connection is fully closed.

A consumer should typically call NdDisconnect only after it gets completions for all work requests it posted to the initiator queue. Otherwise, the NdDisconnect may not lead to a true graceful disconnect. Providers are not required to support graceful disconnect in the case where a consumer leaves such work requests outstanding.

Related topics

Network Direct Kernel Provider Interface (NDKPI)

 

 

Send comments about this topic to Microsoft

Show:
© 2015 Microsoft