The topic you requested is included in another documentation set. For convenience, it's displayed below. Choose Switch to see the topic in its original location.

Constructing and Drawing Curves

GDI+ supports several types of curves: ellipses, arcs, cardinal splines, and Bézier splines. An ellipse is defined by its bounding rectangle; an arc is a portion of an ellipse defined by a starting angle and a sweep angle. A cardinal spline is defined by an array of points and a tension parameter — the curve passes smoothly through each point in the array, and the tension parameter influences the way the curve bends. A Bézier spline is defined by two endpoints and two control points the curve does not pass through the control points, but the control points influence the direction and bend as the curve goes from one endpoint to the other.

In This Section

How to: Draw Cardinal Splines

Describes cardinal splines and how to draw them.

How to: Draw a Single Bézier Spline

Describes a Bézier spline and how to draw one.

How to: Draw a Sequence of Bézier Splines

Explains how to draw several Bézier splines in sequence.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

© 2015 Microsoft