TransmitFileOptions Enumeration

 

The TransmitFileOptions enumeration defines values used in file transfer requests.

This enumeration has a FlagsAttribute attribute that allows a bitwise combination of its member values.

Namespace:   System.Net.Sockets
Assembly:  System (in System.dll)

<FlagsAttribute>
Public Enumeration TransmitFileOptions

Member nameDescription
Disconnect

Start a transport-level disconnect after all the file data has been queued for transmission. When used with ReuseSocket, these flags return the socket to a disconnected, reusable state after the file has been transmitted.

ReuseSocket

The socket handle may be reused when the request completes. This flag is valid only if Disconnect is also specified. When used with Disconnect, these flags return the socket to a disconnected, reusable state after the file has been transmitted.

UseDefaultWorkerThread

Use the default thread to process long file transfer requests.

UseKernelApc

Use kernel asynchronous procedure calls (APCs) instead of worker threads to process long file transfer requests. Long requests are defined as requests that require more than a single read from the file or a cache; the request therefore depends on the size of the file and the specified length of the send packet.

UseSystemThread

Use system threads to process long file transfer requests.

WriteBehind

Complete the file transfer request immediately, without pending. If this flag is specified and the file transfer succeeds, the data has been accepted by the system but not necessarily acknowledged by the remote end. Do not use this flag with the Disconnect and ReuseSocket flags.

Note   The flags Disconnect and ReuseSocket return the socket to a disconnected, reusable state after the file has been transmitted. These flags should not be used on a socket where quality of service (QOS) has been requested, because the service provider might immediately delete any quality of service associated with the socket before the file transfer has completed. The best approach for a QOS-enabled socket is to call Close when the file transfer has completed, rather than relying on these flags.

The following example demonstrates the use of TransmitFileOptions in a call to SendFile. The file "test.txt" is located in the root directory of the local machine. In this example, a prebuffer and postbuffer of data are created and sent to the remote host with the file. To use the system's default thread, UseDefaultWorkerThread is specified.

No code example is currently available or this language may not be supported.

.NET Framework
Available since 2.0
Return to top
Show: