Graphics.FillClosedCurve Method (Brush, Point, FillMode, Single)
Fills the interior of a closed cardinal spline curve defined by an array of Point structures using the specified fill mode and tension.
Assembly: System.Drawing (in System.Drawing.dll)
member FillClosedCurve : brush:Brush * points:Point * fillmode:FillMode * tension:float32 -> unit
Member of the FillMode enumeration that determines how the curve is filled.
Value greater than or equal to 0.0F that specifies the tension of the curve.
This method fills the interior of a closed cardinal spline that passes through each point in the array. If the last point does not match the first point, an additional curve segment is added from the last point to the first point to close it.
The array of points must contain at least four Point structures.
The tension parameter determines the shape of the spline. If the value of the tension parameter is 0.0F, this method draws straight line segments to connect the points. Usually, the tension parameter is less than or equal to 1.0F. Values over 1.0F produce unusual results.
Creates a solid red brush.
Creates an array of four points to define a spline.
Sets the fill mode to Winding.
Sets the tension to 1.0.
Fills the curve on the screen.
Available since 1.1