Share via


Report.ScaleLeft Property (Access)

You can use the ScaleLeft property to specify the units for the horizontal coordinates that describe the location of the left edge of a page when the Circle , Line , Pset , or Print method is used while a report is previewed, printed, or its output is saved to a file. Read / write Single.

Syntax

expression .ScaleLeft

expression A variable that represents a Report object.

Remarks

You can set the ScaleLeft property by using a macro or a Visual Basic event procedure specified by a section's OnPrint property setting.

By using these properties and the related ScaleHeight and ScaleWidth properties, you can set up a custom coordinate system with both positive and negative coordinates. All four of these Scale properties interact with the ScaleMode property in the following ways:

  • Setting any other Scale property to any value automatically sets the ScaleMode property to 0.

  • Setting the ScaleMode property to a number greater than 0 changes the ScaleHeight and ScaleWidth property settings to the new unit of measurement and sets the ScaleLeft and ScaleTop properties to 0. Also, the CurrentX and CurrentY property settings change to reflect the new coordinates of the current point.

You can also use the Scale method to set the ScaleHeight, ScaleWidth, ScaleLeft, and ScaleTop properties in one statement.

Note

The ScaleLeft property isn't the same as the Left property.

Example

The following example uses the Circle method to draw a circle and create a pie slice within the circle. Then it uses the FillColor and FillStyle properties to color the pie slice red. It also draws a line from the upper left to the center of the circle.

To try this example in Microsoft Access, create a new report. Set the OnPrint property of the Detail section to [Event Procedure]. Enter the following code in the report's module, then switch to Print Preview.

Private Sub Detail_Print(Cancel As Integer, PrintCount As Integer) 
 
 Const conPI = 3.14159265359 
 
 Dim sngHCtr As Single 
 Dim sngVCtr As Single 
 Dim sngRadius As Single 
 Dim sngStart As Single 
 Dim sngEnd As Single 
 
 sngHCtr = Me.ScaleWidth / 2 ' Horizontal center. 
 sngVCtr = Me.ScaleHeight / 2 ' Vertical center. 
 sngRadius = Me.ScaleHeight / 3 ' Circle radius. 
 Me.Circle (sngHCtr, sngVCtr), sngRadius ' Draw circle. 
 sngStart = -0.00000001 ' Start of pie slice. 
 
 sngEnd = -2 * conPI / 3 ' End of pie slice. 
 Me.FillColor = RGB(255, 0, 0) ' Color pie slice red. 
 Me.FillStyle = 0 ' Fill pie slice. 
 
 ' Draw Pie slice within circle 
 Me.Circle (sngHCtr, sngVCtr), sngRadius, , sngStart, sngEnd 
 
 ' Draw line to center of circle. 
 Dim intColor As Integer 
 Dim sngTop As Single, sngLeft As Single 
 Dim sngWidth As Single, sngHeight As Single 
 
 Me.ScaleMode = 3 ' Set scale to pixels. 
 sngTop = Me.ScaleTop ' Top inside edge. 
 sngLeft = Me.ScaleLeft ' Left inside edge. 
 sngWidth = Me.ScaleWidth / 2 ' Width inside edge. 
 sngHeight = Me.ScaleHeight / 2 ' Height inside edge. 
 intColor = RGB(255, 0, 0) ' Make color red. 
 
 ' Draw line. 
 Me.Line (sngTop, sngLeft)-(sngWidth, sngHeight), intColor 
 
End Sub

See Also

Concepts

Report Object Members

Report Object