Was this page helpful?
Your feedback about this content is important. Let us know what you think.
Additional feedback?
1500 characters remaining
Export (0) Print
Expand All

Storport I/O Model

This section describes the Storport driver's I/O model and contrasts this model with that of the SCSI Port driver. The Storport I/O model consists of several features designed to make maximum use of the performance potential of high-speed buses and storage devices.

The Storport driver uses a push model of I/O. This means that the driver forwards I/O requests asynchronously to its miniport driver, up to a maximum number of overlapping packets, without waiting for the miniport driver to request input. In the push model, the port driver controls the flow of the I/O requests and pushes requests down to the miniport driver.

On the other hand, the SCSI port driver uses a pull model of I/O. In a pull model of I/O, the SCSI port driver forwards I/O requests to its miniport driver synchronously and waits for the miniport driver to request new input before it sends the next I/O request. Additionally, the miniport driver controls the flow of I/O requests and pulls the requests down from the port driver.

For more information about the I/O model of the SCSI port driver, see SCSI Port I/O Model.

The topics covered in this section are as follows:

Full-Duplex Mode

Half-Duplex Mode: Not Appropriate for Shipped Products

Unsynchronized HwStorBuildIo Routine

Synchronized Access within Unsynchronized Miniport Driver Routines

Access to Scatter/Gather Lists in the Storport I/O Model

Use of Mapping Buffers in the Storport I/O Model

Performance Tip: Completing Requests During HwStartIo

Pre- and Post-Processing of CDBs and Sense Codes

 

 

Send comments about this topic to Microsoft

Show:
© 2015 Microsoft