Quick Start - Enabling Data Capture on an Existing Process

Under certain circumstances it is beneficial to start data capture after a process is initiated:

  • The scenario being analyzed may not occur until well after the application launches.

  • The analyst determines there is no need to analyze the initial heap allocations occurring on process start.

  • Starting data capture on launch can generate extremely large trace files that can take considerable time and resources to analyze, particularly if process heap analysis is being done in conjunction with other WPA event captures.

Capturing event data from an existing process starts heap allocation data collection at arbitrary times in the execution of an application. By not capturing startup allocations and subsequent heap information, the amount of data collected can be significantly reduced.

Start the default kernel logger, NT Kernel Logger, with the BASE flag, from an elevated command prompt:


C:\etl xperf -on BASE

To enable heap tracing on an existing process, substitute the actual process ID for XXX in the following command.


C:\etl> xperf -start HeapSession -heap -Pid XXX  -BufferSize 1024 -MinBuffers 128 -MaxBuffers 128 -stackwalk HeapAlloc+HeapRealloc

Prepare the traces for analysis in the same manner as done for data capture for a process started by WPA.


C:\etl> xperf -stop -stop HeapSession -d heapTrace.etl 

 

 

Send comments about this topic to Microsoft

Build date: 5/5/2012

Show: