A programmable vertex shader is made up of a set of instructions that operate on vertex data. Registers transfer data in and out of the ALU. Additional control can be applied to modify the instruction, the results, or what data gets written out.

Vertex shader version vs_3_0 extends the feature set supported by vs_2_x. Each of the features in vs_2_X that requires a cap to be set, is available in vs_3_0 without requiring the cap.

New Features

New features of vertex shader version vs_3_0 are listed in the following sections.

Indexing Registers

In the earlier shader models, only the constant register bank could be indexed. In this model, the following register banks can be indexed, using the loop counter register (aL):

  • Input register (v#)
  • Output register (o#)

Vertex Textures

This shader model supports texture lookup in the vertex shader using texldl. The vertex engine has four texture sampler stages (distinct from the displacement map sampler and the texture samplers in the pixel engine) that can be used to sample textures set at those stages. See Vertex Textures in vs_3_0 (DirectX HLSL).

Vertex Stream Frequency

This feature allows a subset of the input registers to be initialized at a rate different from once per vertex. See Drawing Non-Indexed Geometry.

Shader Output

Similar to vs_2_0, the output of the shader can vary with static flow control. Be careful with dynamic branching as this can cause shader outputs to vary per vertex. This will produce unpredictable results on different hardware.

Dynamic flow control

All dynamic flow control instructions are supported. The maximum nesting depth value allowed is 24. (See Flow Control Nesting Limits for details.)

Temporary Registers

A total of 32 temporary registers (r#) is supported.

Static Flow Control

The maximum nesting depth for loop - vs/rep - vs is 4. The maximum nesting depth for call - vs/callnz bool - vs/callnz pred - vs is 4. For if bool - vs, the maximum nesting depth value allowed is 24. (See Flow Control Nesting Limits for details.)


Instruction predication is supported. Use setp_comp - vs to set the predicate register.

Instruction Count

Each vertex shader is allowed anywhere from 512 up to the number of slots in MaxVertexShader30InstructionSlots in D3DCAPS9. The number of instructions run can be much higher because of the loop/rep support; however, this is capped by MaxVShaderInstructionsExecuted in D3DCAPS9 which should be at least 0xFFFF.

Device Caps

If Vertex Shader 3_0 is supported, the following caps are supported in hardware (at a minimum):

Shader caps
  • DynamicFlowControlDepth is 24
  • NumTemps is 32
  • StaticFlowControlDepth is 4
  • Predication is supported.
GuardBandLeft, GuardBandTop, GuardBandRight, GuardBandBottom8K
D3DDEVCAPS2_VERTEXELEMENTSCANSHARESTREAMOFFSET Vertex elements in a vertex declaration can share the same stream offset.
Vertex formats


Related topics

Vertex Shaders