Reading from a Serial Port

Windows CE 3.0

An application calls the ReadFile function to receive data from a device at the other end of a serial connection. ReadFile takes the same parameters as the WriteFile function.

Typically, a read operation is a separate thread that is always ready to process data arriving at a serial port. A communication event signals the read thread that there is data to read at a serial port. The thread can read blocks of data into a buffer — one ReadFile call for each byte — until all of the data is read. Then the read thread waits for another communication event. Typically, an application waits for an EV_RXCHAR, then reads (with a very short timeout) all data that is currently available.

For more information about communication events, see Using Communication Events.

To read from a serial port

  1. Pass the port handle to ReadFile in the hFile parameter. The CreateFile function returns this handle when an application opens a port.
  2. Specify a pointer to receive the data that is read in lpBuffer.
  3. Specify the number of characters to read in nNumberOfBytesToRead.
  4. Specify a pointer to the number of bytes actually read in lpNumberOfBytesRead.
  5. Be sure that lpOverlapped is NULL. Windows CE does not support overlapped I/O.

The following code example shows how to receive data using the ReadFile function.

BYTE Byte;
DWORD dwBytesTransferred;

ReadFile (hPort,                // Port handle
          &Byte,                // Pointer to data to read
          1,                    // Number of bytes to read
          &dwBytesTransferred,  // Pointer to number of bytes
                                // read
          NULL                  // Must be NULL for Windows CE
);

 Last updated on Friday, April 02, 2004

© 1992-2000 Microsoft Corporation. All rights reserved.

Show: