2.5.16 Send a Quality of Experience Report

  • Article

This use case, illustrated in the following diagram, describes how a protocol client sends a Quality of Experience (QoE) report after a call is terminated.

Steps for sending a Quality of Experience report

Figure 15: Steps for sending a Quality of Experience report

References

Preconditions

  • The protocol clients are signed in, as described in section 2.5.5.

  • Initiate a voice call, as described in section 2.5.12.

  • Terminate a voice call, as described in section 2.5.15.

Steps

  1. Client A sends a Quality of Experience report to the protocol server, as described in [MS-SIPRE] and [MS-QoE].

  2. The protocol server sends an accept response to Client A.

  3. Client B sends a Quality of Experience report to the protocol server, as described in [MS-SIPRE] and [MS-QoE].

  4. The protocol server sends an accept response to Client B.

Note: A Quality of Experience report is sent by each protocol client independently. Each protocol client sends the report to its provisioned protocol server.

Post-conditions

  • A Quality of Experience report from each protocol client is stored in the database.