Was this page helpful?
Your feedback about this content is important. Let us know what you think.
Additional feedback?
1500 characters remaining
Export (0) Print
Expand All

Stop 7B Error (Windows Embedded Standard 2009)

4/23/2012

Learn what to do when you receive this error message.

  • Be sure the following components are in your configuration:

    • An IDE controller
    • The Primary IDE Channel component
    • The Secondary IDE Channel component
    • A disk drive component
      Bb521473.note(en-US,WinEmbedded.51).gifNote:
      Windows Embedded Standard has three components that contain the name Disk Drive and three .inf files that identify their drivers with the name Disk Drive. To determine the generic disk drive component, you must inspect the properties of each component, and then select the one with the cmiPNPDevID property set to GenDisk.

If you created a configuration based on a Target Analyzer .pmq file, verify that the run-time image is installed on the same device. If it is installed on a different device, this error may occur due to missing drivers for critical devices.

The "Stop 7B" error occurs when your configuration is missing a component that is required to boot your device. Examples of these components include the PCI bus and the IDE controller.

Community Additions

ADD
Show:
© 2015 Microsoft