Core requirements tested
Verifies that the device sensor meets or exceeds minimum height requirement of 32mm.
Ruler or micrometer
Measure touchpad height with a ruler or micrometer.
Assuming Y is the reported sensor width, verify the following:
The measured device width is between Y and (Y + 4).
- Y is >= 32mm.
- The measured device width is between Y and (Y + 4).
If these conditions are true, then manually pass the iteration; otherwise, manually fail the iteration.
Note Because the sensor might be slightly smaller than the cover sheet, the measured height can be as much as 4mm greater than that which is reported by the device.
1/1 (100%) iterations must pass in order to complete with passing status.
ConceptsPrecision Touchpad Tests