Which Type of DPC Should You Use?

Depending on a driver's design, it can have any of the following:

  • A single DpcForIsr to complete all interrupt-driven I/O operations

  • A set of one or more CustomDpc routines.

  • Both a DpcForIsr and a set of operation-specific CustomDpc routines

Whether a driver has a single DpcForIsr routine, a set of CustomDpc routines, or both, depends on the nature of its underlying device and the set of I/O requests it must support.

Most lowest-level device drivers have a single DpcForIsr routine to complete I/O processing for each IRP that requires one or more operations on their respective devices. Using a single DpcForIsr to complete per-request, interrupt-driven I/O operations on a device that does one operation at a time is relatively easy. Such a driver's ISR need only call IoRequestDpc for each interrupt-driven I/O operation.

Few lowest-level drivers have CustomDpc routines unless their devices require more than one DPC to complete a varied set of interrupt-driven I/O operations.

Using a single DpcForIsr to complete overlapped, interrupt-driven I/O operations on a device that can do concurrent operations is possible with careful design, but can be relatively difficult. In addition to or instead of queuing a DpcForIsr, an ISR can queue a set of operation-specific, driver-supplied CustomDpc routines by calling KeInsertQueueDpc.

For example, consider some of the design challenges involved in writing a serial driver. As the driver of a full-duplex device, a serial driver cannot rely on a one-to-one correspondence between the order in which IRPs are queued to a StartIo routine and the sequence of interrupts from its device in a multitasking, multiprocessor system. Furthermore, serial drivers must handle timing out requests and asynchronous user-generated requests to cancel previously requested operations, to purge buffered data, and so forth.

Consequently, a serial driver might maintain internal queues for the read, write, purge, and wait operations that user-mode COM port applications can request. It also could maintain reference counts or use some other tracking mechanism, such as a set of flags, for the IRPs in its internal queues. Its ISR would call KeInsertQueueDpc with any of a number of driver-allocated and initialized DPC objects, each associated with a driver-supplied CustomDpc routine.

 

 

Send comments about this topic to Microsoft

Show:
© 2014 Microsoft