IPowerPolicyCallbackWakeFromS0::OnArmWakeFromS0 method

[Applies to UMDF 1.x only]

A driver's OnArmWakeFromS0 callback function arms (that is, enables) a device so that it can trigger a wake signal while in a low-power device state, if the system remains in the system working state (S0).

Syntax


HRESULT OnArmWakeFromS0(
  [in]  IWDFDevice *pWdfDevice
);

Parameters

pWdfDevice [in]

A pointer to the IWDFDevice interface of the device object that represents one of the driver's devices.

Return value

If the operation is successful, the OnArmWakeFromS0 callback function must return S_OK or another status value for which SUCCEEDED(status) equals TRUE. Otherwise it must return a status value for which SUCCEEDED(status) equals FALSE.

If SUCCEEDED(status) equals FALSE, the framework calls the driver's IPowerPolicyCallbackWakeFromS0::OnDisarmWakeFromS0 callback function. (The framework does not report a device failure to the PnP manager.)

Remarks

Your driver must provide an OnArmWakeFromS0 callback function if the driver supports the IPowerPolicyCallbackWakeFromS0 interface.

The OnArmWakeFromS0 callback function handles device-specific operations that are needed to enable the device to detect an external event that triggers a wake signal on the bus. The kernel-mode bus driver handles bus-specific operations, such as enabling the PCI bus's Power Management Event (PME) signal.

If the driver has registered an OnArmWakeFromS0 callback function, the framework calls it while the device is still in the D0 device power state, before the bus driver lowers the device's power state but after the framework has sent a wait/wake IRP on behalf of the driver.

The process occurs in the following sequence:

  1. The framework determines that the device has been idle for a preset amount of time.

  2. The framework calls the driver's OnArmWakeFromS0 callback function.

  3. The framework requests the driver for the device's bus to lower the device's power.

Immediately before your device enters a low power state, the framework will call your driver's IPnpCallback::OnD0Exit callback function.

For more information about when the framework calls this callback function, see PnP and Power Management Scenarios in UMDF.

You do not need to provide an OnArmWakeFromS0 callback function if your device:

  • Is a USB device that supports "selective suspend."

  • Cannot be powered down while the system remains fully powered.

  • Does not require special hardware operations that enable the device to trigger a wake signal.

If your device supports USB "selective suspend" and if your driver specifies IdleUsbSelectiveSuspend when it calls IWDFDevice2::AssignS0IdleSettings, the framework sends a "selective suspend" request to the USB bus driver when the device has been idle for a preset amount of time.

For more information about this callback function, see Supporting Idle Power-Down in UMDF-based Drivers.

Requirements

End of support

Unavailable in UMDF 2.0 and later.

Minimum UMDF version

1.9

Header

Wudfddi.h (include Wudfddi.h)

See also

IPowerPolicyCallbackWakeFromS0
IPowerPolicyCallbackWakeFromS0::OnDisarmWakeFromS0
IPowerPolicyCallbackWakeFromS0::OnWakeFromS0Triggered

 

 

Send comments about this topic to Microsoft

Show:
© 2014 Microsoft