INF DDInstall.LogConfigOverride Section

[install-section-name.LogConfigOverride] |
[install-section-name.nt.LogConfigOverride] |
[install-section-name.ntx86.LogConfigOverride] |
[install-section-name.ntia64.LogConfigOverride] |  (Windows XP and later versions of Windows)
[install-section-name.ntamd64.LogConfigOverride]  (Windows XP and later versions of Windows)
 
LogConfig=log-config-section[,log-config-section]...] 

Description

DDInstall.LogConfigOverride sections are used to create an override configuration, which overrides the hardware resource requirements that a Plug and Play device's bus driver reports.

Entries

The section entries and values that are used with DDInstall.LogConfigOverride sections are specified within log-config-sections referenced by INF LogConfig directives.

Remarks

The configuration data that is specified in a log-config-section for a Plug and Play device is a preferred hardware resource configuration, but is not an absolute requirement. Some or all of the specified hardware resource configuration data might not be accepted by the device's underlying bus driver. In this situation, the device driver is assigned the hardware resources that were originally reported by the bus driver.

Examples

The following example shows a DDInstall.LogConfigOverride section and a corresponding log-config-section for a PCMCIA device.


[XYZDevice.LogConfigOverride]
LogConfig = XYZDevice.Override0

[XYZDevice.Override0]
IOConfig=2f8-2ff
IOConfig=20@100-FFFF%FFE0
IRQConfig=3,4,5,7,9,10,11
MemConfig=4000@0-FFFFFFFF%FFFFC000
PcCardConfig=41:100000(W)

For more information about the hardware resource configuration data values that are specified in a log-config-section, see INF LogConfig Directive.

See also

DDInstall

 

 

Send comments about this topic to Microsoft

Show:
© 2014 Microsoft