Example 5: Enabling Trace Providers
The following command enables a trace provider for a running trace session named "MyTrace":
tracelog -enable MyTrace -guid MyProvider.guid
In response, Tracelog enables the providers represented by the GUIDs in the MyProvider.guid file. The command does not change any other properties of the trace session.
You can start a trace session and then enable a provider, or you can enable the provider while starting the trace session. For example, the following commands start a trace session and then enable a provider:
tracelog -start MyTrace tracelog -enable MyTrace -guid MyProvider.guid
In contrast, the following command starts the session and enables the providers in one command:
tracelog -start MyTrace -guid MyProvider.guid
Other than timing differences, the effect of these commands is the same.
Typically, tracelog -enable commands are used to change the flags and levels associated with a provider. Because flags and levels are properties of the provider, not properties of the trace session, you use a tracelog -enable command, not a tracelog -update command, to change them.
The following command changes the flags and level for the provider in the MyProvider.guid file. You must use the -guid parameter to specify the trace provider, even when that provider is the only provider enabled for the trace session.
tracelog -enable MyTrace -guid MyProvider.guid -flag 2 -level 2
You can also use the tracelog -enable command to add more providers to the trace session and to re-enable providers that you have disabled by using a tracelog -disable command.
Build date: 11/16/2013