Export (0) Print
Expand All
This topic has not yet been rated - Rate this topic

Winsock 2.0 Test (v4/v6) (Windows CE 5.0)

Windows CE 5.0
Send Feedback

The Winsock 2.0 Test (v4/v6) verifies that Winsock 2.0 and the transport stacks for IPv4 and IPv6 are present on the target device. The test also assesses the functionality of an Ethernet network driver by performing a simple data transfer.

The following table shows the hardware requirements for the Winsock 2.0 Test (v4/v6).

RequirementsDescription
Network interface card (NIC)A NIC that is supported by the Ethernet network driver. Test cases 101 and 102 require a NIC.

The following table shows the software requirements for the Winsock 2.0 Test (v4/v6).

RequirementsDescription
Tux.exeTux Test Harness, which is required for executing the test.
Kato.dllKato logging engine, which is required for logging test data.
Tooltalk.dllApplication required by Tux.exe and Kato.dll. Handles the transport between the target device and the development workstation.
Ws2bvt.dllTest .dll file.
Note   When you run the Winsock 2.0 Test (v4/v6), the CETK temporarily copies files to the root directory of the target device. Before running the test, verify that there is at least 0.2 megabytes (MB) of free space in the root directory of the target device. If there is not sufficient space in the root directory of the target device, the test cannot run.

See Also

Winsock 2.0 (v4/v6) Test Cases


Send Feedback on this topic to the authors

Feedback FAQs

© 2006 Microsoft Corporation. All rights reserved.


Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft. All rights reserved.