Export (0) Print
Expand All
This topic has not yet been rated - Rate this topic

XQuery Operators Against the xml Data Type

XQuery supports the following operators:

  • Numeric operators (+, -, *, div, mod)

  • Operators for value comparison (eq, ne, lt, gt, le, ge)

  • Operators for general comparison ( =, !=, <, >, <=, >= )

For more information about these operators, see Comparison Expressions (XQuery)

A. Using general operators

The query illustrates the use of general operators that apply to sequences, and also to compare sequences. The query retrieves a sequence of telephone numbers for each customer from the AdditionalContactInfo column of the Person table. This sequence is then compared with the sequence of two telephone numbers ("111-111-1111", "222-2222").

The query uses the = comparison operator. Each node in the sequence on the right side of the = operator is compared with each node in the sequence on the left side. If the nodes match, the node comparison is TRUE. It is then converted to an int and compared with 1, and the query returns the customer ID.

WITH XMLNAMESPACES (
'http://schemas.microsoft.com/sqlserver/2004/07/adventure-works/ContactInfo' AS ACI,
'http://schemas.microsoft.com/sqlserver/2004/07/adventure-works/ContactTypes' AS ACT)
SELECT BusinessEntityID 
FROM   Person.Person
WHERE  AdditionalContactInfo.value('
      //ACI:AdditionalContactInfo//ACT:telephoneNumber/ACT:number = 
          ("111-111-1111", "222-2222")',
      'bit')= cast(1 as bit);

There is another way to observe how the previous query works: Each phone telephone number value retrieved from the AdditionalContactInfo column is compared with the set of two telephone numbers. If the value is in the set, that customer is returned in the result.

B. Using a numeric operator

The + operator in this query is a value operator, because it applies to a single item. For example, value 1 is added to a lot size that is returned by the query:

SELECT ProductModelID, Instructions.query('
     declare namespace 
 AWMI="http://schemas.microsoft.com/sqlserver/2004/07/adventure-works/ProductModelManuInstructions";
     for $i in (/AWMI:root/AWMI:Location)[1]
     return 
       <Location LocationID="{ ($i/@LocationID) }"
                   LotSize  = "{  number($i/@LotSize) }"
                   LotSize2 = "{ number($i/@LotSize) + 1 }"
                   LotSize3 = "{ number($i/@LotSize) + 2 }" >
                   
       </Location>
') as Result
FROM Production.ProductModel
where ProductModelID=7;

C. Using a value operator

The following query retrieves the <Picture> elements for a product model where the picture size is "small":

SELECT CatalogDescription.query('
     declare namespace PD="http://schemas.microsoft.com/sqlserver/2004/07/adventure-works/ProductModelDescription";
     for $P in /PD:ProductDescription/PD:Picture[PD:Size eq "small"]
     return
           $P
    ') as Result
FROM Production.ProductModel
where ProductModelID=19;

Because both the operands to the eq operator are atomic values, the value operator is used in the query. You can write the same query by using the general comparison operator ( = ).

Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft. All rights reserved.