Export (0) Print
Expand All
This topic has not yet been rated - Rate this topic

Migrating Custom Property Extractors That Are Defined Prior to Service Pack 1

SharePoint 2010

You only need to consider a migration if you have defined custom property extractors in optionalprocessing.xml. There are two migration alternatives, as follows:

  1. Do not change the existing configuration, but add new property extractors in CustomPropertyExtractors.xml.

    Select this alternative if you do not want to change the existing configuration, and do not have any additional requirements to the existing property extractors.

    For this alternative, you do not need to modify the existing crawled property mapping for these property extractors.

    To create new property extractors, follow the steps in Creating a Custom Property Extractor.

  2. Perform a migration of existing property extractors to the new configuration format. Follow the steps in Migration to the New Configuration File Format.

If you have an existing property extractor configuration that uses one of the processing stages in optionalprocessing.xml, you can perform a migration to the new configuration format.

To migrate a property extraction configuration

  1. Disable the custom property extraction stage in optionalprocessing.xml. Change the active attribute value to no.

  2. Remove the crawled property mapping for the crawled property associated with this stage. For information about crawled property names, see Property Extractor Configuration Using optionalprocessing.xml.

  3. Create a new property extractor. Follow the steps in Creating a Custom Property Extractor.

    • Make sure that you map the generated crawled property to the same managed property as the existing property extractor.

    • You do not need to make any other changes to the managed property configuration or the associated refiner configuration.

    • You do not need to re-crawl content unless you have extended the property extraction dictionary or use one of the new case-insensitive property extractor types.

Note Note

The following configuration option is no longer recommended after you have installed Service Pack 1. It is supported for backward compatibility, and you can keep your existing property extractor configuration if you do not have to modify it.

In <FASTSearchFolder>\etc\config_data\DocumentProcessor\OptionalProcessing.xml, you can define up to three custom whole-word matching property extractors and two custom word-part matching property extractors. You use one of the predefined item processing stages named wholewordsextractor1, wholewordsextractor2, wholewordsextractor3, wordpartsextractor1 and wordpartsextractor2.

Each custom property extraction stage has an associated crawled property and property extraction dictionary.

Table 1 shows the relation between the available property extractors, the crawled property, and the file name for the property extraction dictionaries in the resource store.

Table 1. Relationship between extractor name, crawled property, and file name in resource store

Extractor Name

Crawled Property

File Name in Resource Store

wholewordsexstractor1

wholewords1

wholewords_extraction1.xml

wholewordsexstractor2

wholewords2

wholewords_extraction2.xml

wholewordsexstractor3

wholewords3

wholewords_extraction3.xml

wordpartsexstractor1

wordparts1

wordparts_extraction1.xml

wordpartsexstractor2

wordparts2

wordparts_extraction2.xml

Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft. All rights reserved.