USB Enable Disable Test
Note This content applies to the Windows Logo Kit (WLK). For the latest information using the new Windows Hardware Certification Kit (HCK), see Windows HCK User's Guide on the Windows Hardware Dev Center.
Type: Automated Test
The USB Enable Disable test is a stress test which stresses multiple disables and enable of a device. The test ensures that the device under test is in the attached and configured state after 100ms of being enabled.
Select device to test
- Gather initial information
- Device VID and PID are used to obtain the device instance path
USB Enable Disable test
First the device under test is found in an equivalent way to finding it in the device manager, this ensures that the state of the device is both attached and configured. The test will fail if the device is not found.
- Repeat these steps 20 times
- The device is disabled
- The device is then enabled
- After waiting 100ms the device under test is sought for using the device instance path, to verify that it is both attached and configured. The test will fail if the device is not found
- Run Time:
- Log File:
- System Restart Required: No
- Test Category:
- Supported operating systems for Logo or Signature testing:
Windows Server 2008 R2
Windows Server 2008
The test tool requires the following software:
- Supported operating system (see list above).
- Software components included with the device that is being tested.
- Hardware Requirements
- Device to be tested
Build date: 9/14/2012