NETWORK-0291 - WMC AQ - A wireless home router or WLAN AP must meet HD media streaming requirements for 5.0 GHz (if implemented)
Note This content applies to the Windows Logo Kit (WLK). For the latest information using the new Windows Hardware Certification Kit (HCK), see Windows HCK User's Guide on the Windows Hardware Dev Center.
Type: Automated
Overview
The NETWORK-0291 requirement contains 5.0 GHz Wireless Router High Definition (HD) streaming content Additional Qualifications for the Windows 7 Windows Media Center.
Details
This 1 HD Stream AQ test is a 5.0 GHz wireless home router Additional Qualifications test that qualifies a 5.0 GHz wireless home router for Windows Media Center. One HD stream is used for the test. The HD stream must meet the following requirements to pass the test:
5.0 GHz
22 Mbps minimum
1 Hour duration
Less than 0.1% packet loss
Run Time: 60 minutes
System Restart Required: No
Requirements
Software Requirements
The test tool runs on the following Windows operating systems:
Windows Vista
Windows 7
Software components included with the device that is being tested
Hardware Requirements
The test tool requires the following hardware:
Device to be tested
Computer that meets the minimum software requirements
Windows keyboard
Two-button pointing device
Color display monitor capable of at least 1024 by 768 resolution, 32-bits per pixel, 60 Hz
Hard drive with a minimum of 20 GB available on partition C:
Processor
The test tool runs on the following processor architectures:
x86
x64
Running the NETWORK-0291 5.0 GHz Wireless Router AQ Test
All test cases return PASS or FAIL. Review the test results in the log file for specific details about failures.
To run the NETWORK-0291 5.0 GHz Wireless Router AQ Test:
Set up the test configuration.
Configure the test computers and the machine pool following the instructions outlined for setup of computers in Wireless Router Logo Program Testing.
Create a Network > Wireless Router submission following the procedure in Wireless Router Logo Program Testing.
On the next Create New Submission page, type the device BSSID, MAC Address, and DevicePIN for the Wireless Router under test, and then click Next.
Complete the Wizard.
Select the 5.0 GHz Additional Qualifications test and any other tests you want to run, and then click Add Selected.
Select the jobs and click Schedule Jobs to run the jobs.
Build date: 9/14/2012