The !bpid extension requests that a process on the target computer break into the debugger or requests that a user-mode debugger be attached to a process on the target computer.
!bpid [Options] PID
Controls the additional activities of this command.
The valid values for Option appear in the following table.
Attaches a new user-mode debugger to the process specified by PID. The user-mode debugger runs on the target machine.
Adds a breakpoint that occurs in the WinLogon process immediately before the break in the user-mode process specified by PID. This allows the user to verify the request before attempting the action.
Stores the request in the memory in the target computer. The target system can then repeat the request, but this is not usually necessary.
Specifies the process ID of the desired process on the target computer. If you are using this to control a user-mode debugger on the target computer, PID should be the process ID of the target application, not of the user-mode debugger. (Because process IDs are usually listed in decimal format, you might need to prefix this with 0n or convert it to hexadecimal format.)
Windows XP and later
This extension command is supported on x86-based, x64-based, and Itanium-based target computers.
This command is especially useful when redirecting input and output from a user-mode debugger to the kernel debugger. It causes the user-mode target application to break into the user-mode debugger, which in turn requests input from the kernel debugger. See Controlling the User-Mode Debugger from the Kernel Debugger for details.
If this command is used in another situation, the user-mode process calls DbgBreakPoint. This will usually break directly into the kernel debugger.
The -s option causes a break in WinLogon just before the break in the specified process occurs. This is useful if you want to perform debugging actions within WinLogon's process context. The g (Go) command can then be used to move on to the second break.
Note that there are ways in which this extension can fail to execute:
Lack of resources. The !bpid extension injects a thread into the target process, so the system must have enough resources to create a thread. Using the -a option requires even more system resources since !bpid -a must run a full instance of a debugger on the target computer.
The loader lock is already held. Both !bpid and !bpid -a require a thread to run in the target process in order to make it break into the debugger. If another thread is holding the loader lock, then the !bpid thread will not be able to run and a break into the debugger may not occur. Thus, if !bpid fails when there is enough user-mode memory available for the target process, it is possible that the loader lock is held.
Lack of permission. The operation of the !bpid extension requires permission sufficient for WinLogon to create a remote thread and attach a debugger to a given process.
No access to ntsd.exe. If ntsd.exe is not found in a commonly known path, !bpid will fail to set an appropriate PID. Note that ntsd.exe is not included by default with Windows Vista.
Build date: 4/9/2013